- ページ 11

おもちゃ GREAT PLANES Seawind EPのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Seawind EP 20 ページ。

❏

4. Connect the aileron pushrods to the torque rod horns on

the ailerons with the 90° connectors and to the screw-locks in

the servo arm. Center the ailerons and tighten down the screws

in the connectors with a drop of threadlocker on the threads.

Make sure you have the servo arm screw in the servo.

❏

5. Cut off the extra pushrod wire, but leave approximately

1/4" [5mm to 6mm] protruding from the screw-lock

pushrod connectors.

❏

6. Use the transmitter to operate the ailerons to make sure

they respond in the correct direction. You can set the control

throws now, or wait until you get to the "Set the Control

Throws" section on page 12.

❏

7. Use thick or medium foam-safe CA, epoxy, R/C 56 or

waterproof white glue to glue on the wing tips. If necessary,

use pins to hold them in position while the glue is drying.

GET THE MODEL READY TO FLY

Balance the Propeller & Mount the Spinner

❏

1. For optimum performance and motor efﬁ ciency balance

the propeller using a Top Flite

Balancer (TOPQ5700) or other suitable balancer. Use a

hobby knife or sandpaper to sand the one side of the heavier

blade until you can get the prop to balance.

Precision Magnetic Prop

❏

2. Mount the propeller with the included aluminum

propeller washer. Use a few dabs of RTV silicone, R/C 56 or

waterproof white glue to glue on the spinner. Using just a few

dabs of any of the soft glues recommended should allow the

spinner to be removed if ever necessary in the future. If the

spinner becomes damaged two spares are provided.

❏

1. Test ﬁ t the wing to the fuse. If necessary, trim the foam

block on top of the plywood wing bolt plate in the fuse so it

doesn't interfere with the aileron pushrod wires when you

mount the wing.

❏

2. Mount the wing to the fuse. Use care to tighten the

Phillips wing mounting screw just enough to draw the wing

down to the fuse.