- ページ 6

おもちゃ GREAT PLANES Slinger GPMA1180のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Slinger GPMA1180 12 ページ。 Speed 400 electric fun fly arf

Install the Ailevators

1. Install a control horn on the top of the ailevator with

two 2-56 x 3/8" [9.5mm] screws and the nylon backplate.

The control horn should be in line with the servo arm as

shown in Step 2. Drill 5/64" [2mm] holes for the screws. Note

that the holes in the front of the control horn (for the clevis)

are in line with the hinge line.

2. Thread a nylon clevis twelve turns onto a 12" [305mm]

pushrod. Install a silicone retainer on the clevis. Connect the

clevis to the second hole from the top on the control horn. With

the servo and ailevator centered, mark the pushrod where it

meets the outer hole in the servo arm. Make a Z-bend in the

pushrod at the mark. If necessary, enlarge the hole in the servo

arm with a #48 drill bit (or a 5/64" [2mm] drill). Remove the

pushrod from the control horn and insert the Z-bend into the

servo arm. Connect the clevis to the control horn.

Note: See page 8, Step 2 for an explanation of centering

the ailevators.

3. Return to step one for the other wing panel.

1. Insert the aluminum joiner tubes into the left wing

panel. The longer tube goes in the rear hole.

2. Join the right wing panel onto the joiner tubes in the

left panel. Use the white tape on the bottom of the wing to

hold the wing panels together.