ページを印刷する
Move door(s) up/down
Move door away/towards
the cabinet
Move door(s) left/right
Door Adjustment
base of the cabinet with the supplied screw
and screw cap.
11. Once fully secure, close the internal panel(s)
using the screws removed at stage 6.
12. Fit shelves in desired positions using metal
shelf supports.
13. Re-attach the door / doors ensuring the hinges
fully locate and click back into position.
14. If necessary, the hinges can be adjusted in
order to re-position the door / doors (Fig.D)
15. Switch the mains supply back on.
Operating Instructions
To turn illumination on or off, operate the sensor
switch located at the bottom of the cabinet. Shaver
socket is suitable for recharging toothbrushes.
NB. On first use of the shaver socket, inserting the
shaver plug may prove to be stiff. Reasonable force
may be required to fully insert the plug. Make sure
that the cabinet is held firmly so that it is not pushed
off the wall. After a few uses, stiffness will ease and
the socket will function as normal.
(Fig D)
How to Isolate the sensor so you can switch
ON & OFF with a mains switch!
How the cabinet is wired.
live
earth
neutral
Shaver socket/transformer
Sensor switch controller
LED driver
How to isolate the sensor.
live
earth
neutral
Shaver socket/transformer
Sensor switch controller
LED driver
Re-wire the cabinet as shown in the diagram
above. HiB recommends that all electrical
bathroom products should only be fitted by a
suitably qualified, Part P registered electrician.
For further assistance on isolating the sensor
please contact us.
Tel:
020 8441 0352
Email:
Caution
We recommend that you place this cabinet on a
soft flat surface to ensure no breakages.
We also recommend that you leave corner
protectors on until final fitting.
WEEE compliance
Must not be mixed with general
household waste
3