- ページ 15

照明器具 DAYTAI DT-OLS-116のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DAYTAI DT-OLS-116 16 ページ。 Optical light source

Note：Frequency ID and wave ID cannot be operated at the same time.

To avoid risk of serious eye damage, please do not look into the optical port of laser source at any time.

5.7 Power Off

Automatic power off: When auto-off function is activated, the unit will turn itself off automatically after

10minutes idle time, whatever the power supply is with alkaline batteries or is with power supply adaptor

directly.

Manual power off: Under any operation mode, hold down

Note: With either power off operation, the unit will store the last calibration wavelength and backlight control

mode automatically, which will be the default setting when user turns unit on next time.

Problems

Faint display on the LCD

screen

When on the laser

source, the output

power is not stable

7.1 Always keep the connector ports of your laser source are clean.

7.2 Try to use only the adaptor supplied.

7.3 Once not in use, make sure dust-proof cap is placed properly over the optical ports.

7.4 Carefully plug in/out for fiber connectors/adapters to avoid scratches on the port v of

the power meter.

The light source

Possible cause

Power is off

The battery power is

too low

Optical Light Source (DT-OLS-116)

270Hz

330Hz

1KHz

2KHz

THE MATCHED POWER METER

5-15

for a few seconds to turn the unit off.

After 15 min. preheat

270Hz

330Hz

1KHz

2KHz

Solution

Press

key.

Change the batteries