ページを印刷する
HP- 30/40/50
STEP
STEP
FITTING CHAMBER BLOCKS
4
4
Fit the actuating rod by aligning it with the groove
and tighten U-lock nut and flat washer by the nut
driver.
●Use new U-lock nut and washer, otherwise, U-lock nut
may work loose and cause malfunction.
STEP
STEP
5
5
Insert the actuating rod into the machine body. Be
sure to fit the positioning boss on the diaphragm
base into the concave part of the frame stay.
Secure the diaphragm mounting block on the
other side and tighten washers and U-lock nuts
with the nut driver.
Make sure that gap between the actuating rod
and the electromagnets is even.
STEP
STEP
6
6
Mount the casing block with screws (4screws on
each side).
And insert L-tube into the nozzle of casing block.
Complete the other casing block at the same way.
STEP
STEP
7
7
Install the sound absorber. (HP-50)
●Be extremely careful not to pinch the Sound Absorber
in the Upper Housing.
Place the upper housing back on body.
Fasten it with the bolts.
Then, place the filter and filter cover on the upper
FILTER CLEANING AND
housing. (Refer to
REPLACEMENT
)
REPLACING THE CHAMBER BLOCK
3