- ページ 4

産業機器 Automatic LPM200のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Automatic LPM200 16 ページ。 Stationary roller mill

SAFETY PRECAUTIONS - DURING OPERATION

1. DO NOT wear loose-fitting clothing that may catch in moving parts.

2. Children should not be permitted in areas where machinery of this nature is operating.

3. DO NOT operate this machine until you are sure everyone is clear of the area.

4. NEVER leave the mill running unattended.

5. Always keep hands, feet, and clothing away from moving parts.

DANGER Keep hands and feet out of the hopper when machine is in

operation. Never remove safety grates, or use your hands or feet to dislodge

any obstruction from the mill. Never try to push or force feed grain or snow

that may be bridged or laying in the hopper.

7. NEVER sit or stand on the mill while it is in operation.

8. NEVER adjust or service the unit while it is in operation.

9. NEVER open shields, mill access doors or clean out doors while the mill is in operation.

10.

DANGER Avoid contact between the discharge conveyor and overhead electrical lines. Failure

to heed warnings will result in serious personal injury or death.

11. Hydraulic fluid can cause serious burns. Hydraulic fluid escaping under pressure can have

enough force to penetrate the skin and may also infect a minor cut or opening in the skin. If

injured by escaping fluid, see a doctor at once. Make sure all connections are tight and that hoses

are in good condition.

SAFETY PRECAUTIONS - SERVICE AND REPAIR

1. SAFETY SHUTDOWN PROCEDURE: Working on the mill when it is operating is expressly

prohibited. Never clean, adjust, lubricate, or otherwise service this machine until the following

steps have been taken.

A. Disengage the power source.

B. Lock all switches.

C. Wait until all mechanical motion has stopped on the mill.

Only when these precautions have been taken, should you proceed in the adjustment or servicing

of the mill. Failure to follow the above procedure could lead to death or serious personal injury.

2. Keep the mill in good repair. Good maintenance is your responsibility. A poorly maintained

machine is an invitation for trouble. Always use proper tools when servicing machine, making

certain that they are removed from the unit when services or repairs have been completed.

3. All mills are equipped with shielding to protect the operator from injury. For purposes of clarity

only, some illustrations in this manual may show the mill with the shields removed or missing.

Although shields may be opened or removed for servicing and repair of the mill, they MUST

always be closed or replaced before operation resumes.

405-0525 Rev A

Safety

Page 4 of 16

4/5/16