- ページ 7

ソウ Automatic CS184-AのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Automatic CS184-A 16 ページ。 1500w 184mm (7 1/4”)

c. Lower guard should be retracted manually only for

special cuts such as "plunge cuts" and "compound

cuts." Raise lower guard by retracting handle and as

soon as blade enters the material, the lower guard

must be released. For all other sawing, the lower guard

should operate automatically.

d. Always observe that the lower guard is covering the

blade before placing saw down on bench or floor. An

unprotected, coasting blade will cause the saw to walk

backwards, cutting whatever is in its path.

Be aware of the time it takes for the blade to stop after

switch is released.

e. Do not use abrasive wheels

WARNING. We recommend the use of a residual current

device with a residual current rating of 30mA or less.

Wear goggles

Wear earmuffs

Wear a breathing mask

Accessories

The Automatic Circular saw is supplied with the following

accessories as standard:

1. 184 mm (7 1/4") TCT Blade (fitted)

2. Blade Wrench

3. Parallel Fence

4. Instruction manual

Due to modern mass production techniques, it is unlikely

that your Automatic Power Tool is faulty or that a part is

missing. If you find anything wrong, do not operate the tool

until the parts have been replaced or the fault has been

rectified. Failure to do so could result in serious personal

injury.

The Automatic circular saw is packed fully assembled,

except for the Parallel Fence which will need to be attached.