- ページ 6

エアーコンプレッサー HIBLOW hp-200のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。HIBLOW hp-200 13 ページ。 Air pumps
HIBLOW hp-200 にも：マニュアル (8 ページ), 取扱説明書 (17 ページ)

OPERATION

WARNING:

Lower housing and pump surfaces can become very hot during operation. Do not

touch these surfaces until unit has been shut off and allowed to cool.

CAUTION:

Carefully examine the air pump after installation. It should not be plugged in if

there is water on parts not intended to be wet.

CAUTION:

Do not operate if the cord or plug is damaged, or if the pump is malfunctioning,

dropped, or damaged in anyway.

CAUTION:

Ensure pump is securely mounted prior to operation.

When alternating current is applied to electromagnet as in the figures, the actuating rod moves first

in the arrow direction shown in Fig. 2A and then in the arrow direction shown in Fig. 2B, by the

magnetic attraction and repellent forces exerted between the electromagnet and the permanent

magnets attached to the rod.

The rod vibrates at the power supply(60Hz/50Hz)frequency and changes the volume of the space

enclosed between the head(casing) and the diaphragm. Thus, air intake, compression, and

exhaust, can be performed as the rod vibrates.

Fig. 2A

MAINTENANCE

WARNING:

Always disconnect power before installing or servicing. Failure to do so could

result in electrical shock, personal injury or death. The motor may be thermally

protected and will automatically restart when it cools, if the thermal protection

switch is tripped.

CAUTION:

The filters must be periodically cleaned or replaced. A clogged filter can cause

overheating or pump failure.

Any servicing of the unit other than that recommended in the instruction manual must be performed

by an Authorized Service Facility. Inspection of filters is suggested every three months.

When inspecting filter, also clean inlet port area of filter and housing. Filters can be cleaned with

soap and water. Be sure to dry all parts and filter well before reinstalling. If the pump makes an

abnormal noise, or the amount of discharged air is greatly decreased, turn off the power

immediately.

For repairs or replacement parts, please contact the factory, or send unit to an Authorized Service

Facility.

Fig. 2B

Exhaust

Intake