- ページ 6
電気ヒーター Great World GW-6078TBTのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Great World GW-6078TBT 7 ページ。
ページを印刷する
4. To replace LED lights:
ALWAYS UNPLUG THE ELECTRIC FIREPLACE INSERT BEFORE
PERFORMING ANY MAINTENANCE.
For the strip of LED lights in the front of the unit:
a. Remove the top, and remove the glass panel and logs
from the unit.
b. Unplug the wire at the end of the strip of LED lights.
c. Remove the defective LED light from the plastic strip.
d. Insert the new LED light and plug the wire back on.
e. plug the electrical cord back into the power outlet and
turn on the unit to verify that new LED light works
f. Re-assemble log, glass, and top.
For the strip of LED lights in the back of the unit:
a. Remove the back panel.
b. Unplug the wires that connect the front LED light and
main board.
c. Remove the defective LED light from the plastic strip.
d. Insert new LED light and plug the wires back in.
e. Plug the electrical cord back into the power outlet and
turn on the unit to verify that new LED light works
f. Re-assemble the back panel.
5. Be sure to use Lithium Battery Model CR2025 DC3V. And, make sure
the positive side and negative side follow the instruction on the battery
holder.
PRODUCT CLEANING
GLASS
1.Glass is cleaned during assembly in the factory. However, glass
may get dirty or dust during transition, installation, or operation.
use a clean rug to wipe the surface.
2.To clean fingerprints or other marks, you can use a damp rug to
clean. Use lint to wipe glass clean to avoid water marks. To
avoid scratches, do not use detergent or other sprays to clean
the surface.
EXTERIOR CLEANING
Use a clean damp rug to clean the fireplace outside surface, do
not use detergent.
SERVICE
Other than replacing light bulbs and clean the exterior above,
other changes or cleaning please contact customer service number at
1888-878-8820.
CAUTION :
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE ：
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and the receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Limited warranty for 1 year
Customer service number : 1888-878-8820
Working hours : Mon-Fri, 9:00am - 5:30pm, Pacific standard time.
PRINTED IN CHINA
MADE IN CHINA