- ページ 9

室内暖炉 GreatCo EF71PENのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GreatCo EF71PEN 9 ページ。 Gallery electric fireplaces

In the unlikely event of a problem occurring due to a manufacturing fault within 24 months from the date of purchase

of the appliance it will be repaired or replaced free of charge.

This warranty does not cover consumable items such as the bulbs and fuses which have a limited lifespan.

If a problem should occur, the nature of the problem together with the date of a purchase should be immediately

reported to the retailer that the appliance was purchased from. Proof of purchase will be required so the original receipt

should be retained.

Warranty applies to the original owner only and is non-transferrable.

Problem

Fireplace not responding to remote

commands

Fireplace trips circuit breaker or blows

fuse when turned on

Heater is excessively noisy

Odor coming from heater/blower

Flame effect frozen or stuttering

Heater not outputting heat when turned

on.

LED Lighting not turning on

90236AU GE50-94 REV B 4-26-13

WARRANTY

TROUBLESHOOTING

Possible Causes

Switch on fireplace not in the

ON position

Remote control battery dead

or not inserted properly

Remote is not in range of

fireplace or not aimed

Improper circuit rating

Too many appliances

plugged into the same circuit

Blower assembly is dirty

Defective blower

Normal operation

Defective heater

Defective flame motor

Thermal switch tripped

Heater is defective

Thermostat is cycled off

Front glass panel not

plugged into fire box

Lighting may be defective

For more information, you can visit us online at

Http://www.GreatCo.com

Or Call Us At:

1-651-287-7460

Move closer to fireplace and aim remote

correctly

Ensure unit is plugged into a dedicated 15

Blower replacement or repair necessary

Heater is burning off dust accumulated

during manufacture or non-use periods.

This should only be noticeable for a brief

Heater may require replacement or repair

Turn off unit and unplug for 5 minutes. This

is a safety feature to prevent overheating

Replacement or repair may be required

Plug front panel in according to instructions

Repair or replacement may be required.

Solution

Switch must be in the ON position for

remote operation

Insert or check battery for correct

orientation

directly at it.

amp circuit

Unplug other appliances on the same

circuit

Unplug unit and clean blower

period after turning on.

Flame motor repair or replacement

required.

Set thermostat to higher setting