- ページ 8

室内暖炉 GreatCo GI-32-ZCのPDF ホームオーナー用設置説明書＆取扱説明書をオンラインで閲覧またはダウンロードできます。GreatCo GI-32-ZC 9 ページ。 Electric heater with remote control

ページを印刷する

1. Maintenance

Thermostat control

Your unit contains a 9 Step thermostat-controlled heater ranging from 32-93 degrees F. If room

temperature is too high, turn the thermostat knob counter-clockwise direction; If you need to turn on the

heater, you can turn the thermostat knob clockwise.

To Reset the Heater

Your heater includes a protection system that shuts off the heater if it overheats for any reason:

1) Turn unit to the OFF position.

2) Unplug unit and wait 5 minutes.

3) Plug in again and turn on.

Remote control functions

●

Note: The fireplace Main Power Switch must be switched ON in order for the Remote Control to

function.

Note：

If all light features are turned off and heater is turned on, the heater indicator light will remain lit. If other

light effects are turned on, the heater indicator light will turn off after a short period of time.

In order to protect the product from overheating, there is an 8 second delay when turning on the heater;

also there is 8s delay when turning off the heater fan.

SYMBOL

NOTE:

This remote control uses 1 CR2032 Lithium lon button cell battery (Included). Never

dispose of batteries in ﬁre, except under conditions of controlled incineration. (Failure to

observe this precaution may result in an explosion.)

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against

harmful interference in a residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and

on,

the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

42000 Rev C 8-26-13

TITLE

The Power button will put the fireplace in a standby

mode. This will turn off all functions at once but will

POWER

hold the settings in memory. Except Heater function,

by pressing the button again the unit will turn on at the

same settings.

By pressing the FLAME button, the unit will cycle

FLAME

through four flame effects.

EMBER

By pressing the EMBER BED button, the unit will

BED

cycle through five flame effects.

DOWN

By pressing the downlight button the unit will cycle

LIGHT

through two effects including OFF and ON setting.

Press once for low heater setting (Pilot lights

illuminated ●○).

Press again for high setting. ( Pilot lights illuminated

HEATER

●●)

Pressing a third time turns heat off. ( Pilot lights

illuminated ○○).

FUNCTION