- ページ 9
アンプ DaytonAudio KAB-2150のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DaytonAudio KAB-2150 17 ページ。 2 x 150w class d bluetooth 5.0 amplifier board with tone and volume controls
ページを印刷する
3.
A Bluetooth pairing switch (green) that comes in
the box can be added to the KAB-2150 by
Bluetooth
attaching its 2 pin connector to the corresponding
Pairing
port (J7).
Switch
See the quick start diagram or look for the "BT
Pair" port as labelled on the underside of the
board.
Pressing this button down for about a second will
allow a new device to be paired to the KAB. Do
not hold this button for longer than 5 seconds.
Use this button if you are not seeing "DAKAB" in
your Bluetooth list.
Note: Only use momentary switches for the BT
pairing port.
4.
Once powered on, the board's Bluetooth
connection will be available on your phone,
Bluetooth
tablet, laptop, etc and will show as "DAKAB" in
Connection
your Bluetooth menu. Once connected and music
is playing on the source device, audio should
begin playing through your connected speakers.
Troubleshooting
1. Attach the momentary BT pairing switch
as shown in the previous step and hold it
for a few seconds.
2. Restart your Bluetooth connection on
your phone/tablet/etc and or reset the
whole device.
3. Make sure your amplifier is powered
with an adequate power supply (see
above)
4. Try a different Bluetooth source
5. If you still cannot connect, read the
"Input Devices" section above and
ensure your switch is set to Bluetooth
mode, and you have either a jumper or
aux jack connected to J103.
9