- ページ 12
インターホン・システム Automatic Solutions FBKのPDF インストレーション＆ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Automatic Solutions FBK 17 ページ。 Gsm intercom system
ページを印刷するRestoring defaults
When in programming mode, you can enter the following sequence...
9
9
9
9
When the master code is forgotten....
1) Wire a push button (or replicate with wire link) across the Egress terminal and (-)GND.
2) Switch off power for 1 minute.
3) Switch ON power.
4) during the first 60 seconds, press the EG button once to enable the function.
5) Enter the following code..
8
0
8
0
The keypad should now be in programming mode, ready to accept new data.
Using the standard codes...
Once you have exited out of programming mode, simply enter the user code.
Using super user codes
?
?
?
?
?
?
?
?
?
?
?
?
This cellular intercom can dial up to 4 numbers in sequence for any call button when pressed..
Dialling.....
Any user receiving the call can answer, speak to the visitor, and press the following digits on their
mobile or fixed line telephone to control the relays on the device...
*
Press
key to operate
electric gates or door lock.
Use this normally.
P a g e
| 12
#
*
*
Using the keypad
#
1
Activate output 1
#
2
Activate output 2
#
3
Activate output 3
Using the intercom
Phone 1
1
4
7
*
Phone 2
Press # key to LATCH output
relay. Caution: Use only for
2
3
holding open gates or door!.
5
6
Press 1 to UNLATCH output
8
9
which has previously been
0
#
latched. Use to allow gates/door
to close
Phone 3