- ページ 2

スピーカー DaytonAudio Shadow Sound SS3のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DaytonAudio Shadow Sound SS3 4 ページ。 Micro speakers

The Shadow Sound micro speakers use standard double gang electrical boxes or round ceiling boxes

which are available at most hardware stores. Although they will work with most brands, we recom-

mend using Carlon brand boxes. Pre-construction (new work) and existing construction (old work)

boxes are available depending on your application. Note: Shadow Sound micro speakers should

be mounted in a box and are NOT compatible with "mud ring" style mounting hardware.

Pre-Construction "New Work":

This is the best (and easiest) time to install the micro speakers. Follow these simple instructions:

1. Determine the desired location in the room. Using a hammer mount the box to a wall stud at elec-

trical outlet height (see Fig.1) Make sure that the box protrudes out from the stud around 1/2" so it

will be flush with the drywall surface.

2. Run 18AWG, 2 conductor wire from speaker location to the location of the audio system. For

easier speaker connections, be sure to leave extra wire at both ends.

3. Only after the wall is finished and painted, should you attempt to install the micro speaker. To pre-

vent damage, never install the micro speakers while the house is under construction.

4. Make electrical connections (see below). Using wire cutter / strippers, separate the two conduc-

tors and remove about 1/2" of insulation from each wire. Twist the strands of wire tightly before

inserting them into the crimp connectors. When making connections, it is very important to

observe proper polarity.

5. Install the micro speaker using a hand held straight blade screwdriver. Be careful not to crack the

grill by over tightening the screws.

All manuals and user guides at all-guides.com

INSTALLING SPEAKERS

FIG 1

(2)