- ページ 4

スクーター Hiboy BK1のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Hiboy BK1 9 ページ。 Kids electric bike

4. Debug Brake

1. Loosen the nut with an open-end wrench.

3. After debug Brake as shown in the figure.

2. Pull the brake cable to a suitable position, center the

two sides of the brake pads and keep 4-8cm gap between

brake and wheel. Then lock the screw nut.

5. Charging

Open the rubber plug

Note:

• Your Kids Electric Bike will be fully charged when the LED light on the charger changes from red （charging） to green. When the

battery is fully charged, please STOP CHARGING and unplug the unit.

• Do not charge when there is excessive odor/ heat, Leakage or physical damage.

• Do not connect the charger if the charging port is wet.Keep your charging environment clean and dry at all times.

• If the charging port is damp or has any liquid on it, do not charge your E-Bike.

• In order for the battery to operate at maximum efficiency, avoid charging your E-Bike in extremely hot or extremely cold environ-

ments.

• Use only the battery and charging cable provided to you by HIBOY. If a replacement is needed, please contact HIBOY directly.

Insert the charging plug in

Fill and fix the rubber plug

after the charging