- ページ 12

改札口 Automatic Systems TR491のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Automatic Systems TR491 12 ページ。 Dropping-arm tripod turnstile

3.6.

Temporary dismantling

•

If the equipment has to be temporarily dismantled, e.g. if you need to change its location, follow

the procedure below.

3.6.1.

Unlock and open the front doors (4:1) and (4:2).

Unlock and remove the hood (4:3).

Make sure that the power supply cables are not live.

Put off the main switch (2:1) near the electrical control logic.

Disconnect the power supply wires (2:4) from the main switch (2:1) as well as the earth

cable (2:5).

Disconnect any other cabling (control wires, etc.).

3.6.2.

Loosen the four expansion bolts inside the front and rear end sections, at the bottom of the

housing.

Remove the two fixing brackets from the turnstile.

Note:

Either remove, or cut off floor fixing expansion bolts and make good the floor

surface, protruding fixings are a dangerous risk to the health and safety of persons

using the area.

Using manual handling or fork-lift truck remove the tripod turnstile to safe or its new location

for installation.

3.7.

•

When the equipment is withdrawn from use, proceed with the dismantling procedure as

described in paragraph [3.6. Temporary dismantling]. Ensure that the various components of the

equipment (metals, electrical components, plastics, etc.) are handled, recycled, or disposed of in

the appropriate method, to comply with regulations and codes of practice in the country where the

unit is to be scrapped.

 Automatic Systems TR491-TR6-GB-a YD-JMW 20/01/00

Installation TR491

2-1106GB Rev.: C

p. 12/12