ページを印刷する
13. For your own safety, check the scooter before every use. When you note loosen parts, excessive wear, strange sounds,
and other abnormal conditions stop riding.
14. The scooter is not suitable for jumps.
15. The scooter is suitable for the use of one person only.
16. Immediately replace worn and/or damaged parts.
17. Closely follow the safety instructions in the manual. Hiboy shall not be liable for any financial losses, physical injuries,
accidents, legal disputes, and other interest conflicts resulted from actions that violate user instructions.
8. Starting Out
FOOT POSITION
Before riding, put your foot as close as possible to the front of the deck, and the other foot on the ground. Make sure that
your driving route is clear. To start riding, boost yourself forward with your foot that is on the ground. Keep one foot behind
the other, (it's more comfortable to place one foot forward and the other one turned backward at 70-90°,
like on skate/surfboard). It will help you gain more stability.
HOW TO APPLY THE BRAKE
The scooter is ridden by regularly pushing the foot against the ground. To brake, simply step on the brake plate of the rear
wheel. The braking force can be dosed by a light firm step. Before you ride at higher speeds, you should practice riding at
a slower speed and try to safely come to a helmet. You should basically never ride faster than you can run!
8
9. Maintenance
DAILY CARE AND MAINTENANCE
Check the product for any damage or signs of wear, before and after use. For your own safety, you should not perform
any structural changes and should exclusively use original spare parts that you can purchase from a www.Hiboy.com.
The product should no longer be used if any parts are damaged or sharp corners and edges have emerged.
If you see stains on the scooter's body, wipe them off with a damp cloth. If the stains won't scrub off, put on some
toothpaste, and brush them with a toothbrush, then wipe them off with a damp cloth.
Notes: do not clean the scooter with alcohol, gasoline, kerosene, or other corrosive and volatile chemical solvents to
prevent dire damage.
ROLLER-BEARING CHANGE
Replacement rollers and bearings should be replaced if they are worn out or else abraded. Both are available as an
accessory from www. Hiboy.com. To change the rollers, loosen the axle screw with the provided Allen wrench and remove
the roller from the axle. You can also use the Allen wrench to press the ball bearing out of the wheel, in order to use it again
(we however recommend that rollers and bearings are replaced together). Insert the bearing with the spacer back into the
new roller and use the axle screw to mount both on the scooter. Ensure that the axle is again securely screwed on before
using the scooter. Please tighten the screws regularly.
MAINTENANCE AND STORAGE
When the scooter not in use, keep it indoors where it is dry and cool. Do not put it outdoors for a long time. The ball bearing
is maintenance-free and does not need to be oiled.
9