- ページ 7

電話 GAI-Tronics 354-700YLのPDF マニュアルをオンラインで閲覧またはダウンロードできます。GAI-Tronics 354-700YL 17 ページ。 354-70x series nema 4x voip telephone

NEMA 4X VoIP Telephones

Wiring

1. Remove the four screws from the front panel and turn it to the right so that the interior surface faces

you. Allow the wiring to remain connected. The front panel can be hung from the front door by

hooking a small piece of wire in the mounting holes of the panel. The front panel interior surface and

the back box interior now face you. Refer to Figure 5. This configuration presents the easiest access

for troubleshooting and setting adjustments.

2. Plug the incoming Cat5 data line to the network RJ45 cable jack on the underside of the VoIP circuit

PCBA. See Figure 6.

Install any additional connections as indicated below. Refer to Figure 5 for wiring details. Refer to Table

4 on Page 9 for the recommended conductor sizes.

Network Cable

Connect a Cat5 or Cat5e UTP cable with an RJ45 connector between the Local Area Network (LAN) and

the VoIP PCBA. See Figure 6.

Power-Over-Ethernet (POE)

Connect power to the system as indicated in your POE equipment manual. (Power Mode A, Class 0)

P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-520A.docx

03/17

Figure 5. Installation and Maintenance Configuration

Pub. 42004-520A

Page 7 of 15