- ページ 10

電話 GAI-Tronics Commander CBのPDF インストールとユーザーマニュアルをオンラインで閲覧またはダウンロードできます。GAI-Tronics Commander CB 20 ページ。 Weather resistant telephones

5.2.2

Kit No 100-02-0208-001

This accessory is for mounting GAI-Tronics telephones on to the side of

round poles of 100mm to 200mm diameter, or on to square or

rectangular section uprights of 100mm to 150mm across the mounting

surface.

NOTE:

Banding straps (large scale worm-drive clamps) are not included in this

kit and must be obtained separately. For details of where banding can

be obtained, refer to GAI-Tronics.

1. After punching through the flanged bushes in the rear enclosure (as

described in WALL MOUNTING), attach the pole mounting clamp

assemblies to the rear enclosure using the M6 x 25 screws

provided. Tighten to a torque of 4.5Nm max.

Note: only use the outer four holes, and ensure that the screws seat

properly in the plastic bushes to avoid water ingress.

2. Ensuring that the glands are at the bottom, pass a proprietary

banding strap round each of the pole mounting clamps and the

support pole. Tighten securely.

3. Continue the installation by making the appropriate connections

(section 6) and re-fitting the face plate.

4. Re-tighten the straps firmly and trim off any excess band material.

For security the driving head of the band may also be sawn off.

5.2.3

Titan telephones supplied for flush mounting have a slightly different

faceplate to those supplied with a rear enclosure – in particular the fixing

holes are in different positions and there are no corner cut-outs (for door

hinges). These models are usually described as "Titan fp" and the

supplied mounting kit contains round-headed screws and no glands.

Pole mounting

Flush mounting

Titan CB, Commander CB