- ページ 11

電話 GAI-Tronics Titan CBのPDF インストールとユーザーマニュアルをオンラインで閲覧またはダウンロードできます。GAI-Tronics Titan CB 20 ページ。 Weather resistant telephones

To flush-mount the telephone to a wall:

1. Prepare a recess (at least 50mm deep) in the wall according to the

dimensions shown.

2. Mark the wall with hole centres based on the dimensions shown

(155 x 326mm). If necessary offer the faceplate up to the wall to

check alignment. Do not use the telephone as a template for

drilling.

3. Drill holes in the wall at the marked positions. Select appropriate

screws, wall plugs etc., for the type of wall, bearing in mind that the

weight of the complete phone is around 1.5kg.

4. Route the cable to within the recess, and make connections to the

telephone as shown in section 6.

5. Secure the telephone to the wall taking care not to trap any wires.

Note that the gasket on the rear of the faceplate is intended to make

a weather seal when compressed against a smooth surface. Do not

rely on this gasket to keep water out if mounting directly to rough

surfaces such as brickwork – in these cases use additional sealant

around the edges to ensure a weatherproof seal.

Titan CB, Commander CB