- ページ 2

マザーボード DynaGen GSC400 SeriesのPDF プログラマーズ・マニュアルをオンラインで閲覧またはダウンロードできます。DynaGen GSC400 Series 4 ページ。 For generator
DynaGen GSC400 Series にも：校正ユーティリティ・マニュアル (18 ページ)

ページを印刷する

Getting Started.

Your package should include the following:

1. GSC400 Programmer

2. 10 pin ribbon cable female-to-female

3. Two male-to-male 10pin headers

4. USB printer cable

5. Serial DB-9 cable

6. Installation CD

The GSC400 programming board

consists of a USB-B type connector

(the one usually found on printers,

not the more common A-type

connector that you plug into your

computer), a serial DB-9 female

cable, a programmer port, one push

button, and one slide switch.

The USB and serial cables are used

to connect the GSC400 programmer to the computer. Both are provided as a convenience and

only one should be connected to the board.

The 10 pin ribbon cable plugs into the programming port, red stripe facing the push button. The

other end of the ribbon cable plugs into the controller with the

red stripe facing the center of the unit. The two 10 pin male-to-

male headers plug into the ribbon cable as shown in the diagram.

GSC400 Programmer Manual

Revision 1.0 (22/12/2006)

10 pin Ribbon