- ページ 11

グリル Hickory Industries Rotisseries N/1.9EのPDF インストレーション＆オーナーズ・オペレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Hickory Industries Rotisseries N/1.9E 14 ページ。

WARNING! When setting a cooking time, it is only an estimate of when the product being cooked

will be done! The only way to be certain that a product (such as chicken) is cooked is

by taking the internal temperature of the product (for chicken, it is 185ºF). A load of 9

chickens, with an average weight of 3 lbs. each will take about 90 minutes to cook.

SET

HLd

Once programmed, the contoller will store and save the set points.

Computer Controller Operating Instructions

1. After the N/1.9e computer controller has been programmed, [HLd]will again appear on the display.

2. In addition to the display, there are four buttons on the controller {t}, {s}, {SET}, and {START}.

3. With [HLd] appearing on the display, press the {START} button once to start pre-heating the unit:

Press

Display

HLd

START

HLd

NOTE:

Press the TEMPERATURE and MOTOR switches to the ON position (the top half of

the switches should be flat or down) in order to activate the fans, the heating elements,

and the computer controller.

HLd

###

Once the desired cooking time is entered, press {SET} again and a

blank display with a single dot will appear. This means that all the

values have been entered.

The computer will then automatically display [HLd] indicating that the

computer is not longer in a programming mode.

Result

After pressing {START}, [HLd} will blink, indicating that the unit is

attempting to reach the Set Point Cooking (SPC) temperature. At this

point, the unit can not reach the SPC since the fans nor the heating

elements are on yet

At this point

With the motors and the heating elements on, [HLd] will continue to

blink until the Set Point Cooking (SPC) temperature is reached (in this

example, 400ºF).

To view the actual temperature in the rotisserie, press the {s} button

and the actual temperature inside the cooking chamber will appear on

the display. When the button is realeased, a blinking [HLd] will again

appear on the display.

4900 Westside Avenue, North Bergen, New Jersey 07047

Tel: [201] 223-0050 Fax: [201] 223-0950

Hickory Industries, Inc.

1.9 Manual 10/97

Page 11 of 14