- ページ 13

録音機器 GAI-Tronics 10959-904のPDF マニュアルをオンラインで閲覧またはダウンロードできます。GAI-Tronics 10959-904 20 ページ。 Wall-mount audio messenger interface

Models 10959-903 and 10959-904 Wall-Mount Audio Messenger Interface

Time Set Up

Use the push buttons located on the top edge of the main PCBA to set the time. Complete the following
procedure to set the time:
1. Press <ENTER>, PB4, to enter the menu system.
2. Press <SELECT>, PB3, to scroll to the TIME: display.
3. Press <ENTER>, PB4, to enter the TIME: set up.
4. Press <ENTER>, PB4, to confirm choice.
5. Press <UP>, PB1 or <DOWN>, PB2 to select the desired hour.
6. Press <SELECT>, PB3, to scroll to the minute.
7. Press <UP>, PB1 or <DOWN>, PB2 to select the desired minute.
8. Press <ENTER>, PB4, to accept the TIME: setting.

ACT (AMI Configuration Tool)

Overview

The ACT (AMI Configuration Tool) software is used to define and change configurations for the AMI,
and is included with the unit. The AMI accesses a CompactFlash
with the 10959-903 or 10959-904 product configuration to retrieve configurations and play audio
messages.
Please refer to the ACT software online help for specific instructions.

System Requirements

The ACT software must be installed on a Windows PC (Windows
A reader/writer capable of programming CompactFlash
port. The CompactFlash

CompactFlash

®
®
The CompactFlash
memory card stores the system configuration, speech messages, and alarm tones.
Complete the following instructions to install the memory card:
1. Insert the memory card through the rectangular MEMORY CARD slot on the AMI main board with
the label on the memory card facing up.
2. Slide the memory card in until it is fully seated in the slot.
When seated properly, the card protrudes approximately ¼ inch from the front of the socket.
N
: The memory card and its socket are keyed for proper insertion—do not force the card into the
OTE
socket.
3. Reboot the system so the AMI unit can read the memory card.
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-442D.docx
10/18
®
reader/writer is not included with the AMI.
®
memory card that is pre-programmed
®
XP/7/10) equipped with a USB port.
®
memory cards must be connected to the USB
Pub. 42004-442D
Page 11 of 17