- ページ 2

8014 PRO

Wireless table / wall button

14-12-23 V1.3

Battery empty and replacement of battery:

The lifetime of the battery is about 1,5 year. When it is almost empty it will alarm 3 soft beeps and blink its lights 3 times*,

when the alarm is activated. Additionally, a battery empty message will be sent together with the alarm, as a result of which

the receiver will also show the empty battery. The orientation lighting now blinks every 4 seconds. To remove the battery,

the screw can best be removed (see figure 2) and the PCB (printed circuit board) can be taken out. After the replacement of

the battery type CR123A, you return the screw and the PCB to its original position. Be aware of the + and the - pole of the

battery as is mentioned on the sticker. The placement is easiest by first placing the - pole and then carefully pressing the

+ pole in.

* only if switch 3 and 4 are not both turned OFF.

Closing of the casing:

Place the top with the stripe marking above the hole of the bottom part (figure 3) and

click them into each other. Then turn the topside to the left until the holes are across

each other again and place the screw back.

Test the product for the correct operation.

Turning the button temporarily off:

When the button is not being used for a long period of time (or during storage) the

button can temporarily be turned into sleep mode, which saves the battery. The approaching function and orientation lighting

are then not operational. You put the button into this mode by placing your finger on the button and as soon an alarm will be

made, you press the (mechanical) button quickly 8 times. You will hear a long beep which has turned off the approaching

function and orientation lighting.

You can get the button out of its sleep mode by pressing the red mechanical button once.

Specifications:

Frequency : 869 MHz.

Internal Battery: 3V battery type CR123A

Lifetime battery: +/- 1,5 year

Note: Dispose of used batteries in accordance with applicable regulations.

DAZA Opticare B.V. follows a policy of constant improvements in the development of their products. The technical data can therefore be altered without preceding notification.

This product is classified as an electrical and electronic device. In case you wish to dispose of this product, please make sure this is done in accordance with the European guidelines regarding disposal of electrical and electronic

devices (AEEA) and conform the local legislation in regards to this guideline.

User Manual

Figure 3

P a g e

2

o f

2