- ページ 15

カードリーダー HID MaxiProx DFM Reader - 5375のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。HID MaxiProx DFM Reader - 5375 19 ページ。

HID MaxiProx DFM Reader - 5375 インストレーション・マニュアル
®
MaxiProx
Installation Guide
4.1.2 Output Specification
The specifications of voltage, current, power and timing are from the perspective of the reader. A
common signal ground is defined as a voltage reference that is common to both the reader and the
control panel. The voltages for the data outputs are referenced from the power supply ground located
at the reader. The voltage measured for the power to the reader is referenced from the power supply-
return connection location at the reader, not at the source of the power.
The voltage, current, and timing of the data pulses are measured at the reader in reference to the
power supply/signal ground at the reader. The voltage, current and timing of a signal driving an
auxiliary input device on a reader is measured at the control panel that is controlling the input device
(with reference to the signal ground at the panel).
4.1.3 Signal Levels
The Data One, Data Zero, and LED Control conductors connect signals between the reader and the
panel. The logic levels are defined as follows:

Table 9: Logic Levels

Voltage
Levels
Voh
Vol
Ioh
Iol
4.1.4 Data Pulses
The Data One and Data Zero signals are normally held at a logic high level until the reader is ready to
send a data stream. The reader places asynchronous low pulses on the appropriate data lines to
transmit the data stream to the panel. The following timing parameters shall be observed:
Data One
Voh
Vol
Data Zero
Voh
Vol

Table 10: Data Pulses - Timing Parameters

Tpw
Tpi
March 2012
Data Outputs (Data0 and Data1)
Minimum
Maximum
3.5V
5.5V
0.0V
0.5V
0.0mA
5.0mA
-25.0mA
0.0mA
Tpw
Tpi
Tpw
Pulse Width Time - 30uS (minimum) to 50uS (maximum)
Pulse Interval Time - 1.8mS (minimum) to 2.2mS (maximum)
© 2008-2012 HID Global Corporation. All rights reserved.
Control Inputs (LED's, Hold, Beeper)
Minimum
3.5V
0.0V
-1.0mA
0.0mA
Tpw
Tpi
Part No. 5375-901, Rev E.1
Maximum
5.5V
0.5V
0.0mA
25.0mA
Page 15 of 19