- ページ 4

ネットワーク・ルーター Dynalink RTA300のPDF クイック・セットアップ・マニュアルをオンラインで閲覧またはダウンロードできます。Dynalink RTA300 16 ページ。 Adsl router

Ethernet (connecting up to 4 networked computers, or to a LAN)

Connect using the provided Ethernet cable to any of the Ethernet ports (LAN1

to LAN4) of the router. Up to four computers can be connected. If you have

more than 4 computers or an existing LAN, connect one of the LAN ports of

the router to your network hub. Extra Ethernet cables are not provided.

USB (for standalone Windows 98/ME/2000/XP computers)

Connecting the Router via Ethernet is the preferred option. However if you

decide to connect via the USB port, you must install the USB drivers for this

Router. The drivers are found on the enclosed CDROM. Please refer to Chapter

2: Installation on the User's Manual for step-by-step instructions.

Connect the ADSL Router

Connect the 12V 1A DC power adapter to the PWR jack of the Router, and

plug the adapter into a mains power outlet. Switch on the Router.

Connect the DSL port of the Router to your ADSL jackpoint (telephone wall

socket) with the enclosed phone line cord. Never connect the ADSL Router

through a Microfilter.

Connect any of the LAN ports (LAN1 to LAN4) of the router to the Ethernet

port of your computer using the cable supplied. Up to four computers can

be connected this way. If you have more computers or wish to connect to an

existing LAN connect one of the LAN ports of the router to your network hub.

If you choose to connect via the USB port, do not use the ethernet cable.

Connect the USB port of the router to the USB port of your computer (or a

USB hub) using the USB cable provided.

After connecting the cable (LAN or USB), the corresponding light on the front

panel will turn on. If not it indicates a problem with the Ethernet or USB

connection.

Configure your computer

For a step-by-step guide refer to Chapter 4 - Configuration in the User's Manual.

The description below assumes you are connecting via an Ethernet port.

By default the DHCP server on your ADSL Router is enabled. The simplest

configuration method is to follow option 1 below.

STEP 1

You do not need to specify an IP address when configuring TCP/IP properties.

If your computer stands alone and is set up to obtain an IP address automatically,

you can move on to Section 5 – Going On-Line.

OBTAIN AN IP ADDRESS FROM THE ADSL ROUTER