- ページ 11

エアコン Gree 26TTW09HP230V1AのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gree 26TTW09HP230V1A 16 ページ。 Ttw

AIR CONDITIONER FEATURES

TO OPERATURE ON FAN ONLY:

Note: Use this function only when cooling is not desired, such as for room air circulation. You can choose any fan speed you prefer,

EXCEPT AUTO FAN.During this function, the display will show the actual current temperature, not the set temperature as in the cooling mode

TIMER-DELA

START/ST

RESET

FILTER

Note 1: For Delay Stop, the unit must be in the ON position.

Note 2: For Delay Start, the unit must be in the OFF position.

To adjust timer setting, tap or hold the UP arrow (^) or DOWN arrow (v) to change the delay time by 0.5 hour increments up to 10 hours,

then by 1 hour increments up to 24 hours. The control will count down the timer remaining until start (8, 7.5, 7, etc.). After

set Timer,the unit will enter into Timer mode by 5 seconds, then Timer light on, Set light off. In Timer mode: Set temperature

and fan speed keeps previously set temperature and fan speed; Temperature display set temperature, no display if power

turn off; Press Timer once, LED display remaining time of set time, LED return to set temperature by 5 seconds ;

When in Fan Only mode, LED only display room temperature, do not display set temperature.Turning the unit "ON" o r

"OFF" at any timer will cancel the Delay Start/Stop function. The delay Start/Stop feature will work until the unit either starts

or stops. Once this has happened then the above steps have to be repeated again .

COOL

FEA

RESET

FILTER

Note This feature can be used with any combination of FAN Speeds, Timer .When in the Cooling Mode, the fan will run continuously

while cool is needed. The temperature will automatically be maintained anywhere between 61°F (16°C) and 86°F (30°C). When the room

set temperature is satisfied, the fan will cycle off and on to circulate and sample the room air. If the air conditioner is off and is then turned

on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately 3 minutes for the compressor to

start and cooling to begin.

PRESS TIMER BUTTON

models)

(continued)

PRESS

MODE BUTTON

CHOOSE

FAN ONLY

FIRST DO THIS:

PRESS TEMP/TIMER

BUTTON

PRESS

MODE BUTTON

SELECT COOL

RESET

FILTER

THE TIME CHOSEN:

RESET

FILTER

RESET

FILTER