ロックス DynaLock 2280-TJ80のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。DynaLock 2280-TJ80 8 ページ。 Single/inswing electromagnetic lock

705 Emmett Street Bristol, CT 06010

1-877-DynaLock www.dynalock.com

The Series 2280-TJ80 is a 1200 pound holding force

top jamb mounted electromagnetic lock, designed to

secure a single inswinging door. The lock requires

installation procedures as described herein and in

the separate wiring instructions included.

Typical installation of the lock on a LH single

inswinging door:

Care must be taken that the lock face and armature face are kept free of dirt, rust, paint, or any other obstruction

which may interfere with the lock and armature making good contact. These faces may be cleaned with a non-

abrasive pad and wiped with an oil dampened cloth.

Familiarize yourself with the door and frame conditions. The lock must mount rigidly to the face of the door frame

header. The door mounted armature is supplied with hardware that allows it to pivot slightly to compensate for

reasonable misalignment.

NOTE: If this lock is supplied with the DSM option be certain that magnets are present inside the armature

housing.

After mechanical installation is complete the lock needs to be wired to a 12 or 24 VDC/VAC power source. Once low

voltage power is supplied the unit is fully operational. All other wiring is for selected options. Refer to the separate

wiring instructions included for further information.

2280-TJ80 MANUAL - FORM 2280TJ-001

MODEL 2280-TJ80 SINGLE/INSWING

INSTALLATION INSTRUCTIONS

INSTALLATION DESCRIPTION

HANDLING

MECHANICAL INSTALLATION

ELECTRICAL INSTALLATION

Page 1

ELECTROMAGNETIC LOCK

ARMATURE

2280-TJ80 LOCK ASSEMBLY

ARMATURE

BRACKET

4/07