- ページ 16
室内装飾品 Hiddenbed SPLENDIDのPDF 組立説明書をオンラインで閲覧またはダウンロードできます。Hiddenbed SPLENDID 17 ページ。
ページを印刷するASSEMBLY HAS FINISHED
For proper use:
Check that the floor is clear to lower the bed.
Unlock to change from desk to bed position and lock again.
Stand at the middle of the furniture to pull from bed beam and push down
the desk to make the transformation.
The mechanism is already calibrated to work with the mattress on and a
weight similar to 25 Kg on the desk.
Do not forget to place mattress for adequate functioning.
To open the bed and move the desk down, first unlock the desk then grab
the front bed rail with a hand and push down the desk with the other.To
close the bed, unlock the locking device and pull up the front bed rail.
Always stand at the middle of the furniture to make the transformation and
grab the parts from its center.
It is important to lock the locking device after the transformation and
before the use of the desk or the bed.
Hiddenbed System is based on a desk/bed balance. Unbalanced system
may result on having to apply extra force when transforming from bed
to desk and vice versa. Pin Arm position on arm (A,B,C) helps to balance
unbalanced system (less than 20Kg and more than 20Kg on desk, less
than 10 kg and more than 20kg on bed).
Side panels bears on the floor at the same level. A carpet can be placed
beneath both said adjacent bearing sides, but do not place carpet or
any shim beneath on side desk or body side alone.
Avoid excessive or too asymmetric loads on desk.
While lowering, please verify that bed bottom does not touch things
left on the desk. Things left on the desk cannot exceed 18 inches height.
Next to the rear of the desk there is less height available.
As with a door or a rocking chair, take good care not to trap fingers
between closing parts.
If power or signal cables are to be installed, consult a qualified person.
If the bed does not stay down by itself, lock the locking device.
Ask your retailer for more details.