- ページ 3

ストレージ Hiddn SafeDiskのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Hiddn SafeDisk 13 ページ。

4. Initialization and OS Installation

4.1 Preparing the installation media

For successful installation of an operating system, verify that the computer is able to boot from the installation

media. There are two ways to boot from a specific device:

1. Most computers will let you enter a boot menu by pressing F12 during startup. Some manufacturers use

another key. You can then select the correct boot media from a list.

2. Alternatively, configure BIOS/UEFI to always look for a connected USB, DVD or network bootable media in

the boot order setting.

A new installed Hiddn SafeDisk unit will be recognized as an unformatted disk drive without any boot sector.

4.2 First-time Initialization

The first time you are using the Hiddn SafeDisk unit, you must go through an Initialization procedure, where

you load certificates and configure the unit to allow User Cards to load data encryption keys into the unit. This

is the "Crypto Officer" operation.

1. Power on your computer without installation media

2. Wait for the user interface to start and the message "Waiting for Key Token. Please insert..." to appear

3. Insert the Crypto Officer Card and wait for "Reading Crypto Officer Token..."

4. Enter PIN when prompted and confirm with Enter

5. The process is confirmed by the message "Initialization Started"

6. Wait for the on-screen message "Initialization Finished." Followed by "Press F8 to adjust RTC..."

7. If adjustment of the Hiddn SafeDisk units RTC clock is needed, press F8 and follow the on-screen

instructions. Note that all timestamps are/must be given in GMT.

NB! If RTC time is outside period of SAM Certificate the module will not be functional.

8. Remove the Crypto Officer Card, confirmed by the message "Waiting for Key Token. Please insert..."

4.3 OS Installation

If installing a preconfigured Windows image, the SATA mode used when building the image must be match the

mode set in the BIOS/UEFI. Different modes will result in blue-screen when booting, and this is a well-known

problem with Windows and is not related to the Hiddn SafeDisk

To install the Operating System, follow the instructions below to first load data encryption keys into the unit.

1. Insert the User Card, confirmed by the message "Reading User Token..."

2. Enter PIN when prompted and confirm with Enter

3. Wait for the message "Remove Key Token to continue" to appear

4. Remove the User Key Token

5. Observe that the computer starts normally (i.e. looking for a bootable device)

6. Install the operating system from the selected media

7. It is recommended to load a preconfigured image e.g. over the LAN (PXE boot), make sure the OS' power

settings have disabled all settings for entering "Sleep / Standby Mode".

Hiddn Security AS

Hiddn Safedisk Installation Manual LT02-IM-01-ENG-24.04.2018

http://www.hiddn.no

Page 3 of 12