- ページ 2
マザーボード GainSpan GS1011MIP-EVBのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。GainSpan GS1011MIP-EVB 12 ページ。 Serial to wi-fi evaluation kit
ページを印刷するE
B
VALUATION
OARD
This section describes the various interfaces and jumper settings for the GS1011MxP-EVB board.
Feature
RF Module
RF Output Power (Typical)
Antenna Type
I/O Port (J1 or J2)
LED
WPS Switch (SW2)
Alarm Switch (SW4)
Program Switch (SW3)
On/Off Switch (SW1)
Serial Select Jumper ( J4)
Sensors
Power Source Select (J9)
Battery
Power Mode (J8)
Power Measurement Jumper (J8)
Power Supply Header
Power Source Range
P
RELIMINARY
D
ETAILS
Program
Program
6-pin UART
6-pin UART
Switch
Switch
Connector
Connector
Serial Select
Serial Select
LEDs
LEDs
Jumper
Jumper
GS1011MxP
GS1011MxP
Module
Module
Temperature
Temperature
Alarm
Alarm
On/Off
On/Off
Power
Power
Sensor
Sensor
Light
Light
Switch
Switch
Switch
Switch
Supply
Supply
Sensor
Sensor
Header
Header
Power Mode
Power Mode
Description
GS1011MIP – Internal PA and PCB antenna or
GS1011MEP – External PA and PCB antenna
9 dBm with GS1011MIP
18 dBm with GS1011MEP
On-board PCB Trace (GS1011MxP)
J1: 6-pin serial UART ( 3.3V TTL) or
J2: RS232 DB9 Connector
2 LED's to indicate state
Push button for Wi-Fi Protected Setup
Push button for Alarm and configuration
RUN: Normal Operation (default)
PROGRAM: For programming the GS1011M module:
Power on/off switch
1-2 : RS232 Interface (DB9)
2-3: 6-pin UART (default)
Temperature and Light
1-2: Ext Lab DC power supply
2-3: Battery (default)
Two 1.5V AA Battery (Alkaline or Lithium)
Lithium is recommended for longer battery life
1-2: Always On (Power is always on)
2-3: Standby Mode (Power is turned off to the board during standby state) - default
Jumper to facilitate measurement of current consumption for module
Jumper posts for connecting Lab DC power supply
2.7V to 3.6V
P
2
12
AGE
OF
Serial to Wi-Fi Start Up Guide
RS232
RS232
DB9
DB9
Connector
Connector
Power
Power
WPS
WPS
Source
Source
Switch
Switch
Select
Select
Battery
Battery
Holder
Holder
C
ONFIDENTIAL