- ページ 9

コントロールパネル 2gig Technologies Go!Control PanelのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。2gig Technologies Go!Control Panel 20 ページ。

BURGLARY PROTECTION

When your system was setup by your installer, wireless sensors were placed to monitor

specific doors and windows. The installer selected these doors and windows as likely places

where an unlawful intrusion might occur and could be detected. Each sensor was

programmed to have the system react in a specific way. See "Installer Programmed Options"

on page 41 for specifics about each sensor.

Some sensor types such as smoke detectors, carbon monoxide detectors, panic buttons, etc.

are always active and can trigger an alarm at any time. Other sensors on protected doors and

windows are part of the burglary protection part of the system, and can be turned on or off.

Turning on the burglary protection part of the security system is called "Arming the System".

The burglary protection part of the system can be armed in two modes: Stay mode or Away

mode.

Refer to the floor plan below. It shows a typical residential installation and the various types of

wireless sensors and their functions.

Front and side door sensors have Exit/Entry delay

Side and main garage door sensors have Exit/Entry delay

Control panel

Door/window sensor

PIR

Motion detector

SMKE Smoke detector

PAD

Carbon monoxide detector

Glass break sensor

Wireless keypad

External siren