アダプター DynaMetric TMP-636のPDF 使用方法をオンラインで閲覧またはダウンロードできます。DynaMetric TMP-636 3 ページ。 Telephone transmit & receive patch for use with sound card or tape recorder
DynaMetric TMP-636 にも：マニュアル (4 ページ)

ページを印刷する

DynaMetric

The TMP-636 Telephone Transmit & Receive Patch allows you to record and play back

to your telephone from your sound card or tape recorder. Compatible with carbon and

electret mics.

• Record telephone conversations

• Record just your voice through your sound card (i.e. memos, repetitive, canned

announcements...)

• Playback from your sound card over the phone (announcements, music, phone

conversations, etc.)

Installation is easy, and operation is automatic, with no switches. The TMP-636 is

compatible with analog and digital phones, and standard sound cards and tape

recorders. You can leave it connected to your phone since it does not interfere with

normal telephone operation.

The operation of the TMP-636 is completely automatic. Simply install it according to the

instructions below and operate your sound card controls as usual. Note: Make sure the

"Monitor" switch on your sound card software (if any) is set to OFF to avoid feedback.

Playback can be heard in your earphone and on the other end of the call.

To Install: (See diagram)

Unplug headset (or handset) coil cord from the base of the telephone, and plug the

short modular cord from TMP-636 in its place.

Plug the headset coil cord into the modular jack on the TMP-636.

Insert the 3.5mm stereo plug on long BLACK cord into the speaker or headphone

jack on the sound card or tape recorder.

Insert the 3.5mm mono plug on the long GREY cord into the MIC jack on the sound

card or tape recorder.

FOR LEGAL USE ONLY

www.DynaMetric.com

717 SOUTH MYRTLE AVENUE • MONROVIA, CALIFORNIA 91016-3422

INSTRUCTIONS

TMP-636 Telephone Transmit & Receive Patch

For Use With Sound Card or Tape Recorder

626-358-2559 • FAX 626-359-5701 • 800-525-6925

P/N 44150

Page 1 of 3

8-21-01