- ページ 8

録音機器 DB Drive EUPHORIA EDSP4-31BTのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DB Drive EUPHORIA EDSP4-31BT 15 ページ。 31 band digital sound processor with built-in amplifier

ページを印刷する

Note: The crossover and equalization parameters for each

channel will vary depending on the specific channel and

adjustments made in respect to the equipment used.

Figure 3.5.1

3.6 Output Channel Settings

In Figure 3.5.1, six output channels are being used. The most

commonly used channel output settings are displayed. Users

can customize the speaker type of each output channel. The

output gain, delay, input type, mute and phase settings can all

be adjusted for each seperate channel.

• Gain: The output volume for each channel is controlled by

sliding the fader located below each channel label with a

range of -59dB to 6dB. There is also a master volume of all

output located in the middle far-left of the interface. The

total master volume range is -39dB to 6dB.

• Mute: By selecting the mute button, you can turn the

music signal for the selected channel ON/OFF

Figure 3.6.1

• Phase: Select the phase button to alternate between

positive phase (0°) and inverted (180°).

Figure 3.6.2

• Delay: The 3 possible units of delay are milliseconds

(0.000~7.350ms), centimetres (0~254mm), and inches (0-

100in)

• Output Type: The EDSP4-31BT processor output signal

can be configured to any sound field point and speaker

type. The system factory defaults is set to 4.1 full-range

passive mode.

CHANNEL

OUTPUT

CH1

Front / Left

CH2

Front / Right

CH3

After A Left-Field

CH4

After A Right-Field

CH7

Left Bass

CH8

Right Bass

Users can customize the speaker type for each output channel

by following the steps below:

Step 1: Click "Reset Output" button located on the right side

of the Output Channel Configuration area. Select the "Emptied"

option to set output types on all channels to NULL and

return to the main interface.

Figure 3.6.3