- ページ 3

送信機 ADEMCO 5804BDVのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。ADEMCO 5804BDV 4 ページ。 Two way wireless key with voice status

ページを印刷する

Operating the Buttons

To Activate a Function

To activate a programmed function, press and hold the associated button down until the yellow LED flashes; then release it.

LED

LED Condition

Red

On Steady

Flashing

Green

On Steady

Flashing

Yellow (Right)

Flashing

Yellow (Left)

Flashing

Red & Green

Alternately

Flashing

N/A

To Request System Status

Because the 5804BDV is a two-way device, users can check

the system status before arming or disarming their system. To

check

system

status,

momentarily. The yellow LED will flash after you release the

button. After a second or two, the 5804BDV will display the

system status information using a combination of LED and

sounder activity (see the System Status Indications Table). If

5804BDV does not receive system status information from the

panel for approximately 5 seconds, it will shut itself down. It will

also shut itself down if there is no button activity within 5

seconds of receiving a status update.

This device may not receive the system status

properly if it operates within a few feet of the

5881 RF receiver.

WARNING!

Multiple Button Operations

The 5804BDV should not be used for 24-hour

silent alarm, as the unit itself is not silent.

WARNING!

The 5804BDV can generate the same responses as keypad

panic key pairs of [✶] + [#] and [✶] + [1] by depressing "A" + "C"

and "B" + "D" button pairs, respectively.

FOR LIMITATIONS OF THE ENTIRE ALARM SYSTEM, REFER TO THE INSTALLATION INSTRUCTIONS FOR THE

CONTROL WITH WHICH THIS DEVICE IS USED.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) This device must accept any interference received,

including interference that may cause undesired operation.

System Status Indications Table

System Armed Away

System Armed Stay

Fire Fire Zone (Faulted Zone)

Alarm Alarm Zone (Faulted Zone)

System Disarmed Ready To Arm

System Disarmed Not Ready To Arm System Not Ready, Zones Faulted

––

System AC Loss

Low Battery

press

and

release

any

FCC ID.CFS8DL5804BDV

Speech

You must depress the button pair for at least 2 seconds for the

5804BDV to recognize the button pair command. These button

pairs allow the user to activate panic, fire, and medical alarms

depending on control panel programming.

button

A + C Button Pair

Low-Battery Indication

When the unit goes into a low battery condition, the yellow

LED will not flash when a button is pressed. Change both

batteries

Install/Replace Batteries" paragraph on first page.

Specifications

Physical:

Battery:

FCC STATEMENT

– 3 –

System Status

Armed Away or Maximum

Armed Stay or Instant

Fire Alarm in progress

Armed, Burglary Alarm in progress

Alarm Memory

Disarmed, Ready to Arm

Indicates RF transmission (Non encrypted)

Indicates RF transmission (encrypted)

In Enter House ID Mode

In Enable or Disable Encryption Mode

In Set Volume Level Mode

AC Loss Condition

Low Battery Condition

B + D Button Pair

immediately.

Refer

Belt Clip:

4.1H x 2.2"W x 0.8"D

Transmitter:

3.9"H x 2.0"W x 0.69"D

Maxell CR2430 or Duracell DL2430

5804BDV-005-V0

instructions

in "To