- ページ 7

高圧洗浄機 ActiveProducts 1450のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ActiveProducts 1450 17 ページ。 Electric

ASSEMBLY AND OPERATING INSTRUCTIONS

Caution

• Never use the pressure washer to draw

in water contaminated with solvents

(e.g. paint thinners, gasoline, oil, etc.).

• Dirt in the feed water will damage the

unit. To avoid this risk, we recommend

checking the water filter (located inside

the water inlet; to clean it out see

Maintenance section).

• Always prevent debris from being

drawn into the unit by using a clean

water source and an accessory water

filter if required.

Fig.1

Step 1

Make sure that the ON/OFF switch is in the

"OFF" position.

Fig.3

Step 3

Insert the wand into spray gun, and twist 1/4 turn until rectangular tab appears.

Water Supply (cold Water Only)

Do not draw non-water liquids through the unit. For

•

use with cold water supply only.

Water hose must be at least a 1/2" in diameter.

•

Flow rate of water supply must not fall below 2 GPM

•

(gallons per minute).

Flow rate can be determined by running the water

•

for one minute into an empty 5-gallon container.

The water supply temperature must not exceed

•

104°F (40°C).

Caution

To prolong the life of the unit, it is

recommended to rest the unit 5 minutes

after every 30 minutes of use.

Step 2

Separate the adaptor and quick-connect

coupling. Attach inlet adaptor to the machine's

inlet and attach the quick-connect coupling

onto the garden hose.

Fig.2