- ページ 5

医療機器 Gait up Physilog 6SのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Gait up Physilog 6S 18 ページ。
Gait up Physilog 6S にも：クイック・スタート・マニュアル (6 ページ)

Supply Voltage specifications

The Physilog 6S should be charged using USB at 5V, 100mA. For charging, the ambient

temperature must lie between 0°C and 30°C.

Power supply: 5V DC, 50/60Hz, 100mA

3. Recording with Physilog 6S

There are several ways to start and stop a measurement with the Physilog 6S:

Press on the main button (for about 2 secs, until the green light turns off) to start the

measurement. During measurement, the Physilog® shines green.

Hold the main button for 3 seconds, until the light turns orange to stop the measurement. When

the measurement has been concluded, the LED shortly blinks green three times.

If several Physilog 6S sensors are configured to do so and started at the same time, they

synchronize regularly during the measurement. A network includes one single master sensor

and several slave sensors (from one to as many as wished). Multiple sensor networks can be

created by selecting a different radio channel. The network configuration is done via the

Research ToolKit Desktop software (see RTK user manual for details) and is saved in the conf.bin

file on each Physilog 6S.

To perform a measurement with synchronized Physilog 6S, turn on all sensors of the network

with the main button within a short interval of time (all must be started within one minute). No

precise order of starting the sensors is necessary. Each sensor starts recording data from start

and once it is synchronized with the master sensor it will shine green synchronously with the

master sensor. To stop the measurement, push the main button of the sensors until the LED

turns orange, you can turn off the sensors in any order.

Physilog 6S user manual v1.0.0 Date: 08.01.2021