- ページ 12

コントロールユニット Dynamic DX-ECUのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dynamic DX-ECU 15 ページ。 Environmental control unit

GBK64227 - Issue 3 : August 1998

AFETY AND

ISUSE

ARNINGS

Do not install, maintain or operate this equipment without reading, understanding

and following the proper instructions and manuals, otherwise injury or damage may

result.

The completed installation must be thoroughly checked, and all programmable

options must be correctly adjusted for safe operation prior to use.

A warning must be conveyed to the wheelchair operator that the controller could

cause the chair to come to a sudden stop. In situations where this may affect the

safety of the user, this will require the fitting and wearing of a seat belt.

Performance adjustments should only be made by professionals of the health care

field or persons fully conversant with this process and the drivers capabilities.

Incorrect settings could cause injury to the driver, bystanders, damage to the chair

and surrounding property.

After the wheelchair has been set up, check to make sure that the wheelchair

performs to the specifications entered in the programming procedure. If the

wheelchair does not perform to specifications, turn the wheelchair off immediately

and re-program. Repeat procedure until the wheelchair performs to specifications.

Do not operate the DX System if it behaves erratically, or shows abnormal

response, heating, smoke or arcing. Turn the system off, disconnect the battery or

open the battery overload switch, and consult your Service Agent.

Do not operate your DX System if the battery is nearly flat as a dangerous situation

may result due to loss of power in an inopportune place.

Ensure the controller is turned off when not in use.

No connector pins should be touched, as contamination or damage due to

electrostatic discharge may result.

Most electronic equipment is influenced by Radio Frequency Interference (RFI).

Caution should be exercised with regard to the use of portable communications

equipment in the area around such equipment. While the manufacturer has made

every effort to ensure that RFI does not cause problems, very strong signals could

still cause a problem. If RFI causes erratic behaviour, shut the wheelchair off

immediately. Leave off while transmission is in progress.