- ページ 7

照明器具 HIDRO-DOMESTICS 3LC50 400A3A SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。HIDRO-DOMESTICS 3LC50 400A3A Series 12 ページ。 Linear operators

GENERAL SAFETY REQUIREMENTS

This instruction manual is intended solely for use by qualified professionals.

The installation, electrical connections and adjustments must be made in accordance with the current legislation in each country.

Carefully read the instructions before starting to install the equipment. Incorrect installation can be dangerous.

Packing material (Plastic, expanded polystyrene, etc.) should be disposed of without causing environmental damage and should be kept out of

the reach of children, as it is potentially dangerous.

Do not install electrical equipment in an explosive environment or atmosphere. The presence of gas or inflammable fumes represents a severe

security risk.

Before installing the equipment, make all necessary modifications to the door/gate to ensure that there is no risk of crushing, cutting or any

other possible movement that could cause harm.

The manufacturer of the equipment is not responsible for the automated door/gate not meeting the relevant safety standards, nor for the

possible deformations that could occur during use.

Safety devices (photo-electric cells, pneumatic strips, etc.) should be installed in accordance with the current safety standards. These safety

devices should be installed such as to avoid any possible crushing, cutting or danger in general by the door/gate that is being automated. Apply

the relevant warning sings as per the current standards to indicate the potential danger areas.

Each installation should have clearly visible identification information of the automated door/gate.

Install a two-pole switch at the power supply to turn off the supply in case of emergency.

Check that there is a differential and thermal cut-out.

Always earth the equipment and the door/gate.

MACHINERY DIRECTIVE

According to the Machinery Directive (2006/42/EC) The installer of a door/gate has the same obligations as the manufacturer of a machine and,

as such, must :

Create a technical report for the motorised door/gate which must include the documents specified in Appendix V of the Machinery

Directive. (This technical record should be conserved and made available to the relevant national authority for at least ten years from

the date of manufacture of the motorised door/gate.

Produce the CE conformity declaration for the motorised door/gate as per Appendix II-A of the Machinery Directive.

Put the CE mark on the motorised door/gate as per clause 1.7.3 of Appendix I of the machinery Directive.

DECLARACIÓN DEL FABRICANTE

(Directive 2006/42/EC, Appendix II, part B)

Manufacturer: Hidro – Domèstics, S.L.

Address: C/ Fusteria, 26, 28, 30, 08551 Tona Barcelona – SPAIN

Declares that the systems with part numbers: 3LC*D*, 3LC*RT*, 4LR*D*, 4LR*RT*

Are built to be used in a machine or to assemble with other machines to build a machine considered by the Directive 2006/42/EC, as

modified.

Conform to the conditions of the following CE Directives:

Electro-magnetic compatibility Directive 2014/30/UE, as modified.

Low tension directive 2014/35/UE, as modified.

Safety standard for hydraulic transmission systems EN-ISO4413:2010.

And also declares that it is not permitted to use the machinery until such time as the machine in which it is to be used, or of which is component

part, has been declared in conformity with the conditions of the directive 2006/42/EC and any relevant national legislation.

Tona a 05/10/2016

Jordi Roquet (Director )

- 7 -