- ページ 12

医療機器 GaitKeeper GKminiのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。GaitKeeper GKmini 15 ページ。 Walking surface

5. Troubleshooting

Troubleshooting

Problem: Treadmill belt slips when walking on it

Solution:

Tighten the belt using the instructions below:

Set the treadmill flat and tension and align the belt according to the following procedures:

Connect power and pendant controller to treadmill. Then connect magnetic key.

Keeping the belt centered on both rollers, use a Phillips screwdriver to tighten the tensioning screws evenly until you can no

longer easily see the slots in the channels behind the ends of the rollers.

Turn on the treadmill, starting at its slowest speed, and make sure everything is running smoothly with no out-of-the-

ordinary noises. If the belt quickly runs to one side, tighten the tensioning screw on that side until the belt slowly centers.

Use one foot to apply all your weight to the belt. If the belt sticks to the deck and stops moving, tighten each tensioning

screw in 1/2-turn increments the same amount. Then, retest.

When the belt stops sticking from one foot pressure, speed the treadmill up to 1 mph (9 presses of the speed up command).

Walk heavily on the treadmill. If the belt sticks, tighten each tensioning screw 1/2 turn and repeat.

When properly tensioned, look at how the edge of the belt is running relative to the trim ledge. If it is angling toward the

right at the front of the treadmill, loosen the tensioning screw on the right 1/2 turn. Using either the screwdriver or the 3/16"

Allen wrench, tighten the alignment screw on the front right and of the roller 1/2 turn. Check again and repeat if necessary.

FOR ADDITIONAL ASSISTANCE TROUBLESHOOTING PLEASE FEEL FREE TO CONTACT

litegait.com / 800.332.WALK / 480.829.1727

MOBILITY RESEARCH TECHNICAL SUPPORT 1-800-332-9255