- ページ 7

エアクリーナー ActivePure A1040IのPDF マニュアルをオンラインで閲覧またはダウンロードできます。ActivePure A1040I 16 ページ。

LED DISPLAY

The LED Screen is used to display all current settings (see
page 6) as well as any maintenance reminders.
If a maintenance reminder or a service reminder appears, the
backlight will brighten and constantly flash until the Reminder
Reset icon is pressed or the service problem is corrected.

MAINTENANCE REMINDERS

When maintenance is required, the Display Screen will brighten and flash and the Maintenance Reminder will appear.
• Unplug the unit before performing any maintenance procedures
• Do not operate the ActivePure Surface & Air Guardian without the Filter Assembly and
WARNING
PERFORM CLEANING
The perform cleaning CLEAN indicator will come on approximately every 180 days; for optimal performance, it is
recommended to perform cleaning on your unit every 30 days
Clean the Filter Assembly (See Page 9)
Vacuum the ActivePure Cells
Vacuum Top and Rear Grill openings
NOTE: Be sure to press the Reminder Reset icon to clear the reminder following regular maintenance (See Page 6)
When the CLEAN indicator starts flashing, it reminds you to clean the filter.
Follow the steps below to remove the filter and clean it. While powered on, hold the Reset button, approximately
three seconds, untilyou hear a beep sound alerting you that it has been cleared.
1.
Unplug unit
Back Cover properly installed
2.
Press the top of
the back cover to
release the back
panel
Fan Speed
(5 Levels)
Clean Filter
Assembly
Red Light: ActivePure
3.
Lift up to remove
the back panel
Modes (A·PURE /
A·PURE x2)
x2
Flicker: Replace ActivePure
®
Cell Malfunction
®
4.
Use the included
screwdriver to
unscrew the Filter
Assembly
Ion
Operation
Cell
Hand Strap
5.
Lift the Filter
Assembly up
and out to
remove
7