ページを印刷するFCC Caution.
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
RF Exposure statement
The devices has been tested and meets applicable limits for Radio Frequency (RF)
exposure.
This equipment complies with FCC radiation exposure requirement. The device can
be used in portable exposure condition without RF restriction. Or equivalent meaning.
According to the table of SAR Test Exclusion Thresholds for 100 MHz – 6 GHz and
≤ 50 mm in KDB447498, The minimum distance of SAR Test Exclusion calculated
is 0.36cm. The EUT is at least 0.36 cm away from user's body when used(as showed
in the following picture). It is determined as mobile equipment and complies with the
MPE limit.
The EUT thick is 10mm, and the antenna to body minmum distance is 6.5mm>3.6mm