- ページ 11
PCIカード Dynamic Engineering PCI2PMCのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dynamic Engineering PCI2PMC 15 ページ。 Pci single slot pmc compatible carrier use your pmc in a pc
ページを印刷するConstruction and Reliability
PMC Modules were conceived and engineered for rugged industrial environments. The
PCI2PMC is constructed out of 0.062 inch thick HiTemp FR4 material. The material is
UL recognized per 94V-0. ROHS and non-ROHS assemblies are available.
A cooling cutout has been designed into the product for improved air flow to the PMC.
The components on the PCI2PMC are passive and do not generate an appreciable
thermal load.
Surface mounted components are used. The connectors are SMT for the PMC bus and
through hole for the IO.
The PMC Module connectors are keyed and shrouded. They are rated at 1 Amp per pin,
100 insertion cycles minimum. These connectors make consistent, correct insertion
easy and reliable.
The PMC Module is secured against the carrier with the PMC connectors. It is
recommended, for enhanced security against vibration, that the PMC mounting screws
are installed. The screws are supplied with the PMC from the OEM. Dynamic
Engineering has screws, standoffs, blank bezels and other PMC hardware available at a
reasonable cost if your PMC was not shipped with some of the require attachment
hardware or if it has been misplaced.
Thermal Considerations
The PCI2PMC design consists of passive circuits. The power dissipation due to internal
circuitry is very low. If the PMC installed has high heat dissipation; forced air is
recommended.
The PCIBPMC() series has fan capability. If your PMC is "hot" please consider the
bridged carriers and choose a FAN option to keep your hardware cool. Alternatively
your PC may have sufficient air movement within the chassis to use the passive cooling
designed into the PCI2PMC.
Embedded Solutions
Page 1 1