- ページ 2

コントロールパネル ADEMCO VISTA-20SEのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ADEMCO VISTA-20SE 9 ページ。 2-partitioned security system
ADEMCO VISTA-20SE にも：プログラミング・フォーム (8 ページ), ユーザーマニュアル (4 ページ), プログラミング・フォーム (8 ページ)

Arming Mode

Away

Stay

Instant

Maximum

Arm & Disarm the System

Checking for Open Zones

Using the [*] READY Key

Before arming your system, all protected doors, windows and other protection zones must be closed or bypassed (see

BYPASSING section). Otherwise the keypad will display a "Not Ready" message. Using the READY key will display all

zones that are faulted, making it easier for you to secure any open zones.

To show faulted zones:

1. Press the READY Key – Do not enter security code, but simply press the READY key.

2. Secure faulted zones – Typical fault display shows open zones. Secure or bypass the zones displayed before

arming the system.

3. System can be armed – The "Ready" message will be displayed when all protection zones have been either

closed or bypassed.

you may now arm the system as usual.

Bypassing Protection Zones

Using the [6] BYPASS Key

This key is used when you want to arm your system with one or more zones intentionally unprotected. Bypassed zones

are unprotected and will not cause an alarm when violated while your system is armed. All bypasses are removed when

an OFF sequence (security code plus OFF) is performed. Bypasses are also removed if the arming procedure that follows

the bypass command is not successful.

The system will not allow fire zones to be bypassed. To bypass zones, the system must be disarmed first.

How to bypass protection zones:

1. Enter security code then press bypass. Example: [7] [2] [9] [6] then press the BYPASS key.

2. Enter the zone number(s) for the zones to be bypassed (e.g., 01, 02, 03, etc.). Important: all single-digit numbers

must be preceded by a zero (for example, enter 01 for zone 1).

3. Wait. The keypad will display the word BYPASS along with each bypassed zone number. Wait for these zones to

be displayed, to be sure that intended zones are bypassed.

4. Arm the system as usual when the keypad displays the "Ready" message.

Your system may allow you to easily bypass all open (faulted) zones without having to enter zone numbers individually.

Ask your installer if this feature is active.

Exit Delay

Yes

Entry Delay

Perimeter Armed

Yes

Interior Armed

Yes