- ページ 3

プール照明 Hidrotermal HIDRO-SPOT60HのPDF インストレーション＆メンテナンス・マニュアルをオンラインで閲覧またはダウンロードできます。Hidrotermal HIDRO-SPOT60H 4 ページ。 Embedded underwater led swimming pool light

ページを印刷する

2. Installation

2.1 Preparing to Installation

1. Make sure the pool and its electrical system meets the requirements of the current national or

local electrical codes and ordinances.

2. This light can be installed in concrete pools.

3. This light is designed to be used in new pools and/or pools with existing same swimming lights

that need replacement.

4. Ensure that sufficient area for the niche is dug out to allow the coverage of the entire niche.

5. Use only good quality stainless steel screws or screws provided along with the light.

6. The light must be used or operated while fully submerged underwater only. Never switch on

the light if it is not underwater.

2.2 Installation Notes

1. Make sure to install the niche/housing on a vertical wall of the pool.

2. Make sure the top of the light should be at least 450mm below normal water surface.

3. Backup wire coiled within the niche need to be long enough to reach to the ground, for the

convenience of replacing.

4. The junction box or the 12V low voltage transformer, should be located at least 300mm above

the water surface, at least 200mm above the ground, and at least 1200mm from the edge of the

pool.

5. To achieve synchronization, make sure all the lights are installed correctly on model and

characteristics as the one being replaced.

Junction box

Min. 1200mm

Rigid Conduit

Min. from the junction

box's bottom to water

surface

Water surface

Min. from the top of

lens to water surface

B a c k u p w i r e n e e d

long enough to reach

to the ground

Pool decorative wall

Pool wall