- ページ 17

リモートスターター Automotive Data Solutions AKXのPDF インストールマニュアルをオンラインで閲覧またはダウンロードできます。Automotive Data Solutions AKX 20 ページ。 Remote car starters

Remote staRteR eRRoR coDes:

notes

I WARNING: The following applies only when the parking

lights are connected and supported by the system.

II After a remote starter failure, the parking lights will ﬂ ash

three [3x] times, then will ﬂ ash [X] number times to

indicate an error code. See table.

Remote staRteR shutDown eRRoR coDes:

notes

I WARNING: The following applies only when the parking

lights are connected and supported by the system.

II If the engine shuts down after a remote starter sequence:

Press and hold the Trunk button and the Start button at the

same time for 2.5 seconds when using a 1-WAY remote.

Press once [1x] on button "4" when using a 2-WAY remote.

The parking lights will ﬂ ash four [4x] times, then will ﬂ ash

[Y] number times to indicate an error code. See table.

U.S. Patent No. 8,856,780

Remote staRteR eRRoR coDes - 1 OF 1

Engine running.

Key in ignition at ON position.

N/A

Trunk is open.

Foot brake is ON.

Hood is open.

N/A

Tach failure.

N/A

System is in Valet Mode.

CAN communication failure

RS not synchronized. Start vehicle with OEM key for 15 sec before trying a new RS sequence.

Engine tach signal is lost.

N/A

Foot brake is ON.

Hood is open.

Engine RPM limiter is ON.

Glow plug timeout error.

Vehicle is moving (VSS).

Check engine warning light is ON.

Low fuel warning light is ON.

N/A

CAN communication failure during RS sequence.

AKX-FO(RS)-FO1C-[AKX-FO1]-EN

Page 17 oF 20

• 20150402

DOC.: #21627