- ページ 5

リモートスターター Automotive Data Solutions TR1110AのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Automotive Data Solutions TR1110A 12 ページ。

Your iDatastart system may enable remote engine start by performing one of the following button sequences on

your factory key fob:

BUTTON

Press on

BUTTON

Press on

NOTE: This feature may not be supported on some vehicles. If supported, the chosen button sequence will be

communicated to you by your iDatastart Authorized Dealer at the time of installation. The remote start range

will be equal to your factory key fob's door lock range.

ADJUSTING ENGINE RUNTIME SETTINGS

Once remote started from your factory key fob or long-range remote, your vehicle will run for the programmed

'runtime' setting. The default runtime is 15 minutes but it can also be programmed for 3, 5, 10, 25, 30 or 35

minutes. If you wish to change your remote start runtime setting, contact your iDatastart Authorized Dealer.

The 'key takeover' procedure ensures that your engine does not shut down upon entering the vehicle, during

the programmed remote start runtime. To prevent your vehicle from shutting down, complete the steps below

within the programmed delay time (45 seconds, 90 seconds, 3 minutes or 4 minutes):

For Standard Key Vehicles

1. Unlock and enter vehicle

2. Close doors

3. Insert key into ignition and turn ignition to ON position

FUNCTION

Start engine

Stop engine

FUNCTION

Start engine

Stop engine

TR1110A