アクセサリー Autonics ADS-SEのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Autonics ADS-SE 6 ページ。 Door side sensor

ページを印刷する
Autonics ADS-SE マニュアル
ADS-SE
Door Side Sensor
Features
● Long sensing distance: 0 to 10m
● High ambient intensity of illumination:
Max. 100,000lx of sunlight
● Easy to connect sensor head to controller
● Easy sensitivity setting
(automatic sensitivity setting by one push method)
● Self-diagnosis function
● Compact Size (W77×L44×H30mm)
Please read "Caution for your safety" in operation
manual before using.
Specifications
Model
Sensing type
Sensing distance
Power supply
Power/Current consumption
Contact composition 1c
Contact
※ 1
Contact capacity
output
Relay life cycle
Response time
Output holding time
Available sensor set
Indicator
Light source
Ambient illumination Sunlight: Max. 100,000㏓ (receiver illumination)
Environ-
Ambient temperature -20 to 55℃, storage: -25 to 60℃
ment
Ambient humidity
Protection structure
Sensor cable length
Sensor cable
Material
Accessory
Unit weight
※ 1: Do not use Load which is beyond the rated capacity of contact point of Relay.
It can cause bad insulation, contact fusion, bad contact, relay breakdown, and fire etc.
※ Please purchase 1 set of sensor separately when mounting 2 sets of sensor.
※ The mounting bracket of sensor (ADS-SB12, ADS-SB10) is sold separately.
※ It is enable to purchase a controller separately.
※ The temperature or humidity mentioned in Environment indicates a non freezing or condensation environment.
C-10
ADS-SE
Through-beam type
0 to 10m
12-24VAC ±10% 50/60Hz / 12-24VDC ±10% (ripple P-P: max. 10%)
AC: Max. 2VA / DC: Max. 50mA
50VDC 0.3A (resistive load)
Mechanical- Min. 5,000,000 operations, Electrical- Min. 100,000 operations
Approx. 50ms (from light OFF)
Approx. 500ms (from light ON)
2set
Operation indicator: Red LED, Green LED(Refer to C-14 to 15 for the display status in operation)
Infrared LED (850nm modulated)
35 to 85%RH, storage: 35 to 85%RH
IP30 (IEC standard)
10m
Ø2.4mm, 1-wire, 5m (AWG26, core diameter: 0.16mm, number of cores: 7, insulator out diameter: Ø1.32mm)
Sensor - Holder: Acrylonitrile butadiene styrene, Lens: Polymethyl methacrylate,
Lens guide: Polycarbonate, Nut: Cu-Zn
Controller - Housing: Acrylonitrile butadiene styrene, Cover: Acrylonitrile butadiene styrene,
LED CAP: Polymethyl methacrylate, Bolt: Steel chromium molybdenum (brass, Ni-plate)
Sensor: 1 set (ADS-SH), Fixing bolt for controller: 2 pieces
Approx. 300g