- ページ 8

アンプ Galactron MK 2225のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Galactron MK 2225 10 ページ。

The cable are bad.

The speakers are hooked-up incorrectly.

The power cable are interrupted.

A fuse might as blown into the amplifier's PC board.

The amplifier goes into PROTECTION mode, (power led orange)

One external or internal fuse might has blown.

Have the internal fuses checked by a suitable Service Station.

After being turned on with the power switch, the amplifier goes in stand-by and then goes On

automatically, regarding less the commands sent with the remote control. Symmetrically, once turned

off with the remote control, the amplifier goes in stand-by for four seconds and then goes On again.

Continues Power

Inputs

Signal to Noise Ratio

Peak Current Output

THD (at rated power)

Remote control

Weight

Check that a correct signal is output by the source.

If the output signal is correct,

Check the electrical continuity of the cables and jacks.

If they are not interrupted,

Check that the speakers are correctly connected to the output

If the connection are correct,

Check the continuity of the cables.

If they are not interrupted,

Have the amplifier checked from a suitable Service Station.

Check the external or internal fuse might has blown.

Check the external 3.5 A (or 7 A) main fuse.

The factory installed plastic plug has been removed.

Plug-in again the plastic lug or a simple RCA pin jack NOT short

circuited.

TECHNICAL SPECIFICATION

MK 2225

2x25 W 8Ohm class A

2x38 W 4Ohm class A

2x40 W 2Ohm class A

4 unbalanced RCA

1 balanced XLR

s/n 100db

60Ah

1.6%

infra red

27 Kg

terminals.