- ページ 9

セキュリティセンサー DBI SALA LAD-SAF 5000338のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DBI SALA LAD-SAF 5000338 12 ページ。 Static wire rope grab for 3/8 inch wire cable

ページを印刷する

Component:

Lad-Saf Wire Rope Grab

Lifeline

Lanyard

Full Body Harness

6.0 CLEANING, MAINTENANCE, AND STORAGE

6.1

Periodically clean the Lad-Saf Wire Rope Grab using water and mild detergent. Clean the label as required.

6.2

Replacement parts and additional maintenance and servicing procedures must be completed by an

authorized service center. An authorization and return number must be issued by DBI/SALA.

6.3

Clean and store system components according to the manufacturer's instructions.

6.3

Store the wire rope grab in a clean and dry environment out of direct sunlight. Avoid areas with chemical

vapors. Inspect the wire rope grab after extended storage.

7.0 LAD-SAF WIRE ROPE GRAB SPECIFICATIONS/PERFORMANCE DATA

7.1

SPECIFICATIONS:

•

Weight: 2.25 lbs. (1 kg)

•

Overall Dimensions (including detent pins): 10.5 x 2.5 x 5.5 inches (26.7 x 6.4 x 14.0 cm).

•

Materials: Stainless steel.

7.2

PERFORMANCE DATA:

•

Arrest Force: Designed for 1,800 lbs (8 kN) maximum arresting force.

•

Maximum Capacity: 310 lbs (141 kg)

•

Applicable Standards: OSHA 1910.66, Appendix C

Table 2 - Inspections Schedule & Checklist

Inspection:

Inspect the detent pins (A). The button should spring back when

pushed down. The pins should slide easily through the wire rope grab

body and wedge/handle assembly.

Inspect the function of the wedge/handle assembly (B). The handle

should move freely, with no sticking or binding. The wedge must

engage and lock onto the lifeline. The handle spring must be in place

and undamaged.

Inspect the lanyard attachment D-ring (C). The D-ring must be free

of corrosion, cracks, or other deformities. The bracket and pin holding

the D-ring must be undamaged.

Inspect the wire rope grab body (D). The wire rope grab body must

be free of wear, corrosion, cracks, or other deformities.

All labels and markings on the wire rope grab must be present and

fully legible (E). (See "Labeling").

Record the inspection date and results in the Inspection and

Maintenance Log in this document.

Inspect the lifeline (F) according to the manufacturer's instructions.

Inspect the Lanyard per the manufacturer's instructions.

Inspect the Full Body Harness per the manufacturer's instructions.

Pass

Fail